Search Results: ED*

18-CH103D1-1B-EN_07212020

Document Title:	Installer's Guide BAYBACKSPACER Supplementary Blanking Strip
Publication Type:	Installation
Publication Date:	2020-07-30

electrical power, including remote disconnects before installing or servicing. Follow proper lockout/tagout procedures to ensure the power can not be inadvertently energized. Failure to disconnect power before servicing could result in death or serious injury. SAFETY HAZARD! Sharp Edge Hazard. Be careful of

18-CH67D1-1_04122013

Document Title:	Service Installer's Guide KIT09370 (Retrofit Kit CNT02223)
Publication Type:	Installation
Publication Date:	2013-04-12

hot. Failure to follow this warning could result in severe burns. � WARNING!The cabinet must have an uninterrupted or unbroken ground according to National Electrical Code, ANSI/NFPA 70 - "lat-est edition" and Canadian Electrical Code, CSA C22.1 or local codes to minimize personal injury if an

18-CH97D1-3A-EN_04082020

Document Title:	Installer's Guide High Altitude Conversion Kit for S8 and A8 Furnaces BAYSWT**AHALTA
Publication Type:	Installation
Publication Date:	2020-04-08

high speed. Please note that with the reduced firing input rates required for high altitude installations, the induced draft blower has ample capacity to provide sufficient combustion air for proper and safe operation. Refer to the National Fuel Gas Code - latest Edition 11.1.2 - High Altitude and

18-GJ05D1-12A-EN_04162020

. Sequence of Operation................................................................................................ 36Section 19. Checkout Procedures................................................................................................... 37 SAFETY HAZARD! Sharp Edge Hazard. Be care-ful of

18-GJ79D1-1F-EN_08032020

Document Title:	Installer's Guide Slim Fit Filter Box Kit for TEM/A4AH4/TVM Series A Cabinet Air Handlers
Publication Type:	Installation
Publication Date:	2020-08-11

responsible for the interpretation of this information, nor can it assume any liability in connection with its use. SAFETY HAZARD! Sharp Edge Hazard. Be careful of sharp edges on equipment or any cuts made on sheet metal while installing or servicing. Personal injury may result. CAUTION Section 2. General

18-HE104D1-1-EN_06202019

Document Title:	Envirowise Installation Instructions EDHUM120 Whole House Ventilating Dehumidifier
Publication Type:	Installation
Publication Date:	2019-06-01

The Envirowise 120V is a whole house ventilating dehumidifier that is integrated into the heating and cooling system to provide the ultimate in comfort and property protection through: • Dehumidification • Fresh Air Ventilation (Optional) • Air Filtration TS-1092 6/19 Rev A P/N: EDHUM120 Serial No

18-HE108D1-1-EN_06202019

Document Title:	Envirowise SD12 Installation Instructions EDHUMS12 Split System Dehumidifier
Publication Type:	Installation
Publication Date:	2019-06-01

design allows the sensible heat load generated from dehumidifying the house to be released in the outside condensing unit, thus eliminating additional cooling requirements. TS-980 5/19 Rev A P/N: EDHUMS12 Serial No.: Install Date: Installing Dealer: HVAC Installer: Please Leave Manual for Homeowner

18-HH35D1-1B-EN_07082020

Document Title:	Installer's Guide Critter Kit - KIT19134
Publication Type:	Installation
Publication Date:	2020-07-15

thatthe top surface of the critter foam is 1/4 inchabove the top edge of the control box panelin the middle. NNoottee:: At the outside edges of the control boxpanel, the top surface of the critter foam shouldbe approximately 1 inch above the top edges ofthe control box panel. This reduces clearancesand

88-A801X001-1C-EN_04202020

Document Title:	RunTru/Ameristar Installer's Guide Upflow/Downflow/Horizontal Left/Right Gas-Fired, Single Stage Induced Draft Furnaces with High Efficiency Motor A801X
Publication Type:	Installation
Publication Date:	2020-04-01

fired equipment, wiring, plumbing,and flue connections must be adhered to. In theabsence of local codes, the installation must conformwith latest edition of the National Fuel Gas Code ANSIZ223.1 / NFPA 54. The latest code may be obtainedfrom the American Gas Association Laboratories, 400N. Capitol St

88-A951X001-1D-EN_05082020

Document Title:	RunTru/Ameristar Installer's Guide Upflow/Horizontal and Downflow Gas-Fired, Direct/Non-Direct Vent, Single Stage Condensing Furnaces with High Efficiency Motor A951X
Publication Type:	Installation
Publication Date:	2020-06-08

edition of the National Fuel Gas Code ANSIZ223.1 / NFPA 54 • National Installation Code, CAN/CGAB149.1. The latest code may be obtained from theAmerican Gas Association Laboratories, 400 N. CapitolSt. NW, Washington D.C. 20001.1-800-699-9277 or www.aga.org. These furnaces have been classified as