Search Results: 18-HD83D1-5B-EN

18-HD30D2-2_08012007

Document Title:	Installer’s Guide ZZSENSAL0800AA
Publication Type:	Installation
Publication Date:	2007-08-01

Installer’s GuideZZSENSAL0800AA ALL phases of this installation must comply with NATIONAL, STATE AND LOCAL CODES Remote Indoor Temperature Sensor( Use with *CONT800 Series Comfort Controls) 18-HD30D2-2 APPLICATIONThis Wall Mount Temperature Sensor is used with*CONT800 Series Comfort Controls

18-HH08D12-1_05012007

Document Title:	Installer's Guide - Outdoor Sensor BAYSEN02 (Use with *CONT800 Comfort Controls)
Publication Type:	Installation
Publication Date:	2007-05-01

3270 3403 D_06172008

Document Title:	Installing the Frame-Mounted Tracer AH541 Controller
Publication Type:	Installation
Publication Date:	2008-06-17

power lines±1.0 kV signal lines IEC 1000-4-5:1995EN61000-4-5 ±2.0 kV IEC 1000-4-6:1996EN61000-4-6 10.0 V0.15 to 80 MHz IEC 1000-4-8:1993EN61000-4-8 IEC 1000-4-11:1994EN61000-4-11 When and Where IssuedElectromagnetic Emission: 05/18/2001Electromagnetic Immunity: 05/18/2001 Mark of Compliance: John

ACC-SVN275A-EN_06202023

Document Title:	0 to 100% Standard Economizer – Downflow Foundation™ Cooling and Gas/Electric 7.5 to 12.5 Tons
Publication Type:	Installation
Publication Date:	2023-06-20

). Economizer Controller 12 ACC-SVN275A-EN Figure 11. Potentiometer and LED locations (W7212 shown) CONTROL CURVE A B C D E CONTROL POINT APPROX. °F (°C) AT 50% RH 73 (23) 70 (21) 67 (19) 63 (17) 55 (13) 12 14 16 18 20 22 24 26 28 30 32 34 36 38 40 42 44 46 90 100 80 70 60 50 40 30 20 10 ENTHALP Y—BTU

BAS-SVN111D-EN_05282020

Document Title:	PM014 DC and AC Power Supply Module
Publication Type:	Installation
Publication Date:	2020-05-28

these steps to install power wiring:1. Perform lockout/tagout procedures for line voltage power to the cabinet.2. Install power input wire for the 24 Vac input connection by using 18 AWG wire and the recommended connector.Refer to BAS-SVX33x-EN for acceptable output current versus wiringdistance. Note

DLR-SVN006B-EN_02252026

Document Title:	Side Discharge Heat Pump
Publication Type:	Installation
Publication Date:	2026-02-25

values are given inTable 7, p. 16 for flare nut.e. Insert. Refrigerant Line Connections 18 DLR-SVN006B-EN Figure 21. Wrench using guide Braze the Refrigerant LineNote: A2L equipment shall have red marked service ports and pipes through which refrigerant is serviced.1. Remove caps or plugs. Use a

BAS-PTS010A-EN_11152024

Document Title:	Symbio™ 800 Integration Points List LonTalk® for CenTraVac™ Simplex/Duplex Water-cooled Chillers with Symbio™ Controls
Publication Type:	Points List
Publication Date:	2024-11-15

Symbio™ 800 Integration Points ListLonTalk®CenTraVac™ Date:11/15/2024Reference Document: BAS-SVP084*-EN Profile Definition and Network Variables The following tables are sorted as follows: • Tables are listed by unit/profile type and sorted by network variable number.• Tables are sorted by name and

CVHE-SVX005E-EN_04112026

080L 31442 26917 33122 28597 360–500 455 080L 080L 33463 28333 35143 30013 Dimensions and Weights 18 CVHE-SVX005E-EN Table 5. Representative weights, 60 Hz chillers (lb) (continued) ModelComp Size CPKWEvap Size Cond Size Weights without Starters Weights with Starters NTON EVSZ CDSZ Operating

18-GJ80D1-1-EN_03012017

Document Title:	Installer's Guide Hydronic Heater Relay Kit BAYWAKIT24VACA For use with communicating TAM9 air handlers with BAYWA hydronic heaters
Publication Type:	Installation
Publication Date:	2017-03-01

this installation must comply with NATIONAL, STATE AND LOCAL CODES 18-GJ80D1-1-EN 03/17 Model:BAYWAKIT24VACA Section 1. General InformationThe BAYWAKIT24VACA kit includes a wire harness and relay. The kit is for use with the TAM9 air handler when using a BAYWA 05, 07, 08, and 11 hydronic heating coil

18-CH40D1-2A-EN_07172020

Document Title:	Service Installer's Guide KIT14668- VARIABLE SPEED INDUCER.
Publication Type:	Installation
Publication Date:	2020-07-30

www.americanstandardair.com The manufacturer has a policy of continuous data improvement and it reserves the right to change design and specifications without notice. We are committed to using environmentally conscious print practices. © 202018-CH40D1-2A-EN 17 Jul 2020 Supersedes 18-CH40D1-2 (January 2009)