Search Results: 18-CH94D1-1C-EN

Showing 391 - 400 of 7,186 results

Display results per page.
  • Media type icon

    18-GJ81D1-1A-EN_08052020

    Document Title:Installer's Guide Air Handler Downflow Sub-Bases TAYBASET
    Publication Type:Installation
    Publication Date:2020-08-11
    /2TEM*A0D 26-1/2 14-1/2TAM*A0A 16-3/4 16-1/2TAM*A0B 20-1/2 16-1/2TAM*A0C 22-3/4 16-1/2 TAYBASETAMA TAYBASETEMA 18-GJ81D1-1A-EN 05 Aug 2020 Supersedes 18-GJ81D1-1-EN (February 2017) About Trane and American Standard Heating and Air ConditioningTrane and American Standard create comfortable, energy
  • Media type icon

    ODR-SVX001D-EN_04172026

    environmental effects. Electrical ODR-SVX001D-EN 19 System Start-Up1. Confirm that “Refrigerant Line Brazing,” p. 11 through “High Voltage,” p. 18 have been completed.2. Turn on the disconnect(s) to apply power to the indoor and outdoor units. 3. Wait one hour before starting the unit if the
  • Media type icon

    GANE-SVX001B-EN_08282020

    Document Title:Separated Combustion Tubular Gas Fired Direct Spark Propeller Unit Heaters
    Publication Type:Installation Operation and Maintenance
    Publication Date:2020-08-28
    should be installed in accordance with the instructions included with the fan. 10. Vent connectors serving Category I and Category II heaters shall not be connected into any portion of mechanical draft systems operating under positive pressure. 18 GANE-SVX001B-EN Venting Horizontally Vented Unit Heaters
  • Media type icon

    18-CD33D1-11-EN_02012019

    Document Title:Installer's Guide High Efficiency Single Stage Upflow/Horizontal and Downflow/Horizontal Gas-Fired, Direct Vent Condensing Furnaces *UH1-H, *DH1-H (* first letter may be A or T)
    Publication Type:Installation
    Publication Date:2019-02-01
    /HORIZONTAL 18-CD33D1-11-EN © 2019 Trane All Rights Reserved 18-CD33D1-11-EN Installer’s GuideSAFETY SECTION The following safety practices and precautions must be followed during the installation, servicing, and operation of this furnace. 1. Use only with the type of gas approved for this furnace. Refer to
  • Media type icon

    18-HE43D1-7B-EN_07082020

    Document Title:Installer’s Guide Heat Pump Snow Legs Kit
    Publication Type:Installation
    Publication Date:2020-07-15
    any liability in connection with its use. WARNING! 18-HE43D1-7B-EN Heat Pump Snow Legs Kit BAYLEGS004 (4-inch), BAYLEGS007 (7-inch) INSPECTION:Check carefully for any shipping damage. This must be reported to and claims made against the transporta-tion company immediately. Any missing parts should
  • Media type icon

    ODR-SVX027A-EN_03202026

    Document Title:Condensing Units
    Publication Type:Installation Operation and Maintenance
    Publication Date:2026-03-20
    connections and cap all unused wires. Mitigation Board Guidelines• The approved ID/OD combination will provide sufficient safe ventilation in case of a leak.• Refer to Indoor Unit Installer’s Guide for correct specifications on indoor unit install. Electrical 18 ODR-SVX027A-EN • All systems require
  • Media type icon

    18-HD80D1-6F-EN_08102023

    Document Title:ComfortLink™ II XL1050 Communicating Connected Control, TZON1050 Installation Guide
    Publication Type:Installation
    Publication Date:2023-08-10
    local distributor. 18-HD80D1-6F-EN Installation Guide 2 18-HD80D1-6F-EN 1. SafetyNOTE: Use 18-gauge color-coded thermostat cable for proper wiring. Shielded cable is not typically required. Keep this wiring at least one foot away from large inductive loads such as Electronic Air Cleaners, motors
  • Media type icon

    ACC-SVN242E-EN_02202026

    Document Title:Drain Pan Overflow Switch Precedent™ Packaged Rooftop Units 3 to 25 Tons
    Publication Type:Installation
    Publication Date:2026-02-20
    , and C cabinets, connect the COF switch pigtail, route the harness below the drain pan, then connect to theintermediate connector coming from the IOM/CCM (see Figure 15, p. 16, Figure 16, p. 17, and Figure 17, p. 18). Installation 16 ACC-SVN242E-EN Figure 15. Cabinet A, B, and C routing – stainless
  • Media type icon

    18-HE142D1-1A-EN_11202024

    Document Title:Energy Recovery Ventilator (ERV)
    Publication Type:Installation
    Publication Date:2024-11-21
    immediately. Open carton, remove packing material, loose parts and ship-with literature. Check to be sure all major components are in the unit. Any missing parts should be reported to your supplier at once, and replaced with authorized parts only. 18-HE142D1-1A-EN Energy Recovery Ventilator (ERV
  • Media type icon

    ACC-SVN228E-EN_09122025

    Document Title:Electric Heaters – Precedent™ Packaged Rooftop Units 3 to 25 Tons
    Publication Type:Installation
    Publication Date:2025-09-12
    . Electric heat control panel mounting SCREWS ACC-SVN228E-EN 15 Installation 17. Connect the heater element wire harness(es) to the contactors. 18. Connect the wire harness from the terminal block to the bottom side of the heater fuse blocks. Pay close attention to the proper L1/L2/L3 connections for